OBD2 Cable for VAD15 - Universal

This is the VADpro OBD II cable for the VAD15. With it the installation is done in a few minutes all OBD 2 values can be shown on the display! Also engine error codes can be displayed!

OBD pin	description	Display pin
1	* Terminal 15 (ignition plus - not all vehicles)	A5
4 + 5	Dimensions	A1
6th	Can high	B2
14th	Can Low	B3
16	Permanent plus (12V)

* If the CC22720 cable is used, pins 1 and 16 are not assigned, but are led out as a separate cable.

Can bus

The Can Bus settings must match the vehicle. By default, these are set that fit most vehicles:

1. "Settings": Speed ​​= 500, CanTerm = ON

The display tests itself whether 11bit (Can2.0A) or 29bit (Can2.0b) identifiers are supported by the control unit.

Supported values

These values ​​are preset and cannot be changed:

• Speed ​​(RPM)
• Engine load
• Fuel Pressure
• Boost pressure (MAP)
• Vehicle speed
• Ignition angle (IgnAng)
• Intake temperature (IAT)
• Air mass (MAF)
• Oil temperature (OilTemp)
• Fuel pressure relative to inlet vacuum (FuelRail)
• Water temperature (CLT)
• Lambda1-8
• Cat temperature bank1 sensor 1 (CatTemp1)
• Cat temperature bank1 sensor 2 (CatTemp2)
• Cat temperature bank2 sensor 1 (CatTemp3)
• Cat temperature bank2 sensor 2 (CatTemp4)
• Additionally 4 analog inputs

Analog inputs

In addition to the OBD2 values, sensors can also be fed in via the four analog inputs. More about this here:  Analog inputs